The new Injector Dynamics ID2000 flows 2200cc/min at 3 bar (43.5psi) and is high impedance. That means no injector resistor or injector driver is needed. With the capability of running up to 130psi and flowing 3700cc/min, the needs for running multiple injectors per cylinder are gone on all but the most demanding methanol applications.
With the most linear flow in itís class, great atomization and full injector dead time information provided, there really is no competition for the ID2000.
Check out this VIDEO to see how well they run in a worst case scenario, a bone stock 120hp car!
Each injector includes the necessary adaptor top and electrical connector. The adaptor tops mechanically lock to the injector and also incorporate a 7 micron replaceable filter.
Please take note of the part number you are ordering as there are a few variations available. The first number after ID2000 is the size (in millimeters) of the top of the injector, the second number is the height of the injector in millimeters. For example: ID2000-11-60 is an ID2000 injector with an 11mm top and a height of 60mm. This is the standard B-Series Honda injector.
These injectors come with Crimp and Wire clips, which means you will have to cut off your factory harness injector clips and wire up the clips that come with these injectors. The pins and clips are included with your injectors at no extra cost and make for a very clean, straightforward installation.
If you are confused, please call or email so we can make sure you understand before ordering online!
Visit www.InjectorDynamics.com for more information.