Haltech PRO Plugin ECU for S2000 (AP1)

Features:

Direct plug and play replacement of the OEM ECU, no re-wiring necessary.

Uses the cars factory sensors

Supports Honda's VTEC Control

Supports Sequential Injection (peak and hold) and Direct fire ignition

Windows 2000, XP, Vista, Windows 7 compatible software

Real time programming, instant hesitation free adjustment while engine is running

Fully user definable 32 x 32 mapping

Tuning via Volumetric Efficiency (VE), Injection time or Lambda Correction (MAF)

Diagnostic trouble code storing & Check engine light control(Access through laptop only )

Selectable onboard internal MAP sensor rated to 150kPa (up to 1.5 Bar or 22psi boost)

Wideband “auto tuning” using user definable target AFR table

USB and CAN Communication Port

Factory Outputs:

4 x Fuel Injector outputs

4 x Ignition outputs

VTEC, Coolant Gauge, AC Clutch Relay, Idle Control

Thermo Fan, Check Engine Light, Fuel Pump

Factory Inputs:

MAP sensor, Throttle Position Sensor, Knock Detection sensor

Coolant Temperature sensor, Vehicle Speed Sensor

Air Temperature sensor, Power Steering Switch, Narrowband Oxygen sensor

Expansion I/O*:

2 x Analogue Voltage inputs

2 x Analogue Temperature inputs

4 x Digital Outputs

*Optional auxiliary harness required to be purchased Haltech Part # HT040003

Functions:

VTEC On - INJ / IGN Tables

VTEC On - CAM Table

Closed Loop O2 Control

Decel Cut Over Boost Rev Limiter

Closed & Open Loop Boost Control

Gear Setup

Transient Throttle Enhance

Knock Control

Long Term Fuel Trim

Correction Tables: Fuel Ignition Boost:

Cranking

Air Temp Target Correction

Zero Throttle Gear Correction

Cylinder Trim

TPS Correction

Generic Correction 1

Generic Correction 2

Gear Correction

Post Start

Air Temp Duty Correction

Post Start

Miscellaneous:

Data Logging: 448Kb of onboard data logging, Storage for approx 40 minutes at 10 logs per seconds, 6 channels of data

Max 20 channels logging capability

Tune can be password protected in software

Rugged anodized aluminum casing

Power Requirements:

Source: 8.6 to 16.5 Volts DC

Consumption: 530mA @ 12Volts DC

Physical Dimensions:

ECU Dimensions Length: 154mm (176mm with MAP nipple)

Width: 158mm Height: 42mm Weight: 680g (1.5 lb)

Applications:

Honda S2000 (AP1)

The Kit includes:

Pro Plug-in ECU, USB Cable, Programming Software CD, Quick Start Guide, Instruction Manual (on CD)