Xenocron Tuning's new WHEEL SPEED SENSOR Kit for Do-It-Yourselfers
This kit allows you to easily add a Hall Effect sensor to your vehicle for monitoring wheel speed, shaft speed...etc, anything you can think of that can use it. Wire it in to an extra Wheel Speed Input on your Standalone Engine Management System or replace your Transmission mounts VSS (vehicle speed sensor) to use Rear Wheel speed (Ground Speed) versus Front Wheel Speed.
- Magnetic Hall Effect Speed Sensor
- 10' Shielded 3 conductor wire
- Male and Female 3 Pin Deutsch DT Connector
- Includes (4) Open Barrel crimp pins (male/female)
- Deutsch wedge and locks
Now with option of adding on Bolt On Mounting Brackets (for vehicles that came with ABS from the factory). If your vehicle did not come with ABS, you can either drill and tap your hub or weld the bracket easily to the hub.
NOW AVAILABLE IS THE MALE SIDE CONNECTOR FOR A FACTORY HONDA V.S.S AND WILL WORK WITH B/D/H/F AND ANY K-SERIES TRANSMISSION THAT USES A PHYSICAL GEAR TO MEASURE SPEED.