Xenocron Turbo Filter Installation

***BEFORE YOU ORDER YOUR TURBO FILTER, YOU MUST MEASURE THE OUTSIDE DIAMETER OF YOUR TURBO’S COMPRESSOR INLET AND ORDER THE SAME SIZE FILTER!!!!***

filter1.JPG

Materials needed:

1.      Xenocron turbo filter

2.      Appropriately sized coupler (measure ID” for coupler)

3.      Two appropriately sized hose clamps (worm clamps work fine)

Tools needed:

1.      Screwdriver or socket to tighten hose clamps

2.      Razor blade or other tool to cut coupler if necessary

 

Installation Instructions:

*READ ALL THE STEPS BEFORE BEGINNING THE INSTALLATION*

·         Measure or estimate the amount of room you have between the turbo’s compressor inlet and any obstructions in your engine bay.  You may need to cut down your coupler slightly.

                                                              filter2.JPG

                                                             filter3.JPG

 

 

·         Once your coupler is cut to the appropriate length, place the turbo filter INSIDE the coupler.

                                                filter7.JPG

·         Place the two hose clamps over the coupler, and place the coupler on the turbo inlet.  GENTLY tighten the clamps. 

*Over-tightening the hose clamp on the filter end can cause it to be distorted so be careful*

filter4.JPG

The finished product should look like this:

filter6.JPG