Logo.gif

DemonBoard Install

 

Your Demon Board Kit should include:

1.      2 strips of pins, each with 14 pins

2.      A Dip/Zif combo

3.      A 4 Pin cable to connect the board to the ECU VIA datalogger Port

4.      USB 2.0 Mini-B to Std-B Bulkhead/Bracket/Kit

5.      Ferrite Bead  for 4.5mm USB Cable

6.       CN2 Latching Header

7.      USDM Chip Kit

8.      White Spacer

9.      Demon Board

 

Chip Your ECU as you normally would using the USDM supplied Chip Kit.

USDM-chipped.gif

  *If your ECU was previously chipped for Hondata S300, take the Dual Wipe Socket included, and press that into the bottom side of the Demon Board.  Then carefully press the Demon Board onto the Male pins in the ECU.

 

Take the 2 Rows of Male/Male Pins and Gently press them into the underside of the Demon Board.

Gold-header-install.jpg

 

Now take the white space and screw it in so that the long part is on the top-side of the Demon Board and the screw is on the otherside.

whitespacer.jpg

 

 

Gently and carefully line the pins up on with the Dip Socket in the ECU.


demonpressinecu.jpg

 

whitespacerpressin.jpg

Now Attach the Datalog Cable to the Demon Board and to the ECU.

datalog-cable.jpg

 

datalog-cable2.jpg

 

Now take the Provided USB 2.0 Mini-B to Std-B Bulkhead and plug that into the Demon Board (Zip Tie it like pictured for extra security)

USB-2.0-Mini-B-to-Std-B-Bul.jpg

Now, If you are installing the Demon Board into a OBD1 USDM P72 with a Daughter Board, you will have to shave down some of the plastic on the USB 2.0 Mini-B to Std-B Bulkhead. On the end that connects to the Demon Board, shave some of the plastic off as such:

shaved-USb.jpg

 

shaved-USb2.jpg

 

You are going to have to bend some of the components down gently on the daughter board for it to fit comfortably.

bent-comp.jpg

bent-comp2.jpg

If you are installing the Demon Board into a JDM ECU you will also have to bend down some of the components CAREFULLY and GENTLY by the chipping portion of the board.

JDMinstall.jpg

 

JDMinstall2.jpg

JDMisntallcomplete.jpg

 

 

 

The White Spacer will hit on the components on the daughter board in the ECU

whitespacerjdm.jpg

Trim the spacer carefully and refit until everything fits comfortably and does not cause unnecessary pressure.

whitespacerjdmtrim.jpg

 

Now put 2 screws in the ECU before you put the cover on and drape the USB cable out and assemble the Covers.