PHP Advanced Transfer Manager

1.bin LS/VTEC GSR Head , USDM ITR pistons , Skunk2 IM , I/H/E

SPLDan

3.bin Built B16 , 9:1 JE , Eagle Rods , RC 550cc , 3 bar MAP , 60 Trim , 16psi , Pump

SPLDan

7.bin Stock B16 , 57 Trim , PTE 440 , Stock Map , 8psi

SPLDan

B201000SC61.bin B20 Vtec, SC61, 1000cc, street tuned on 18psi 3 bar Map

quicksol95

B20Vtec.IACVDelete.Bin GOOD for Stock LS-V (b18a1 Bottom, OBD-1 B16 Top)

UberTUNED

Crome-Stock-TypeR-P73-240cc.bi Stock Type R basemap

YC

Crome4.bin B18b, 450cc injectors, SC34 Turbo, 7psi tuned, timing untouched...bleh

xenocron

GSRSC611000.bin 1.8l GSR 1000cc Injectors, Skunk Stage 1 Cams, SC61 11.2s on 14psi

quicksol95

JCbaseNO2step.bin 81.5mm stock sleeve, cp/eage B18C + SC61 w/ inline pro mani and 3" dp, 750cc saturated RC's. Basemap only, can possibly use some ign. cleanup & tuning.

MaxPower

JoeyBuiltB16.bin Built B16 , 9.2:1 CP's and Eagle H-Beams , PTE 880cc , SC61 , GM 3 Bar , ITR Cams , Made 387WHP @ 15lbs

SPLDan

Jon-Ls-DA-4.bin OBD1 B18a, 450cc DSMs, stock MAP, tuned to 7psi on t25 Turbo, timing is untouched 'base'

xenocron

JoshTurbolsvtec1.bin LSVTEC 10:1cr 14b turbo 450cc injectors 5000vtec 7200rev 8psi, runs good, could use some more fine tuning 11.5-12:1 a/f in boost

Speedz

New turbo civic map.bin b18b1 T3 super60 .48 hotside 7PSi tune, 11.3 in boost, 12.5-12 before boost, 14.70 everywhere else, Needs a little touch up in boost portion, .75 degreee retard per Lb. timing untouched

LScivicT3

RedHatchDynoTune.bin B18B LS, CTR pistons, Crower 404's, RC370cc inj., stock IM/TB, header, 2.5" exhaust, 13.7 afr's, 145hp/122tq

gearhead313

RuebenDynoTune.bin B16 , Skunk2 Stage 2's , I/H/E 160/105tq

SPLDan

StockGSRTUNEP30BASE.BIN P30 Base GSR Street Tune, good starting point...tuned by Dennis McIntosh

xenocron

Wesbase880cc3bar8partial.bin Built 1.85 liter LS/VTEC, DIY log with eGay "super T70", Precision 880cc and GM 3 bar. Tuned to 8 psi, ran into ignition problems at higher psi. IACV was broken, will crank and start but needs idle tuning.

Joseph Davis

cheoh.bin B16A stock with 4-1 header , ECU P30 manual , AFR 12.5-13.5 160HP

kacheoh

chris550-ls-101-3bar.bin Stock ls, 550cc rc injectors, gm 3 bar, tuned mid 11 afrs @ 18 pounds of boost, little bit of timing added for the c16 gas i was running

rx7tocivic

final-tune.bin 300whp / ~260 TQ - B18b, 450cc DSMs, Motorola 2.5 Bar MAP, dyno tuned to 15psi on SC34 Turbo 57 trim, 2.5" mandrel exhaust and DP, Inline Pro Mani, Skunk2 IM, Hondata gasket, JRC 6" FMIC

xenocron

final.bin Stock GSR motor / 9-10psi / 50 trim t3/t04e / 450cc DSM injectors / Jordan will have to update on the FMIC, Mani & Exhaust Setup

xenocron

frankieLSVTAK.bin Built GSR eagle rods , 9:1 SRP's , SC61 , GM 3 Bar , 10lbs , RC 550 Runs awesome

SPLDan

ryantegafter.bin 2.0 GSR, t3/67, 18psi, 1000cc injectors

quicksol95

stock-ls-jason.bin Uber p75 map modded in Crome to run well on a B18A1 bone stock, no boost. Most changes are in ignition and idle.

FooK

test.bin Stock Type-r Bin (still needs a little tuning) stock gsr timing map from 3500 rpms to redline in vtec, stock b16 timing maps else where

slow90hatch

todabin.bin B18C GSR head mild PnP, .5mm over In&Ex valves/ITR cams/JG IM, 83mm 10:1 cp/crowers/sleeved, SC63 T3/T4 P-trim, custom semi tubular, 3" dp, 1000cc, ign dyno tuned till 18psi, 19-26 psi fuel tuned but ign can use tuning, it was not played with on high boost pulls cuz my ic piping and spark plugs were

MaxPower

treyb20.bin Stock b20 bin

quicksol95

v2-stock-ls-jason.bin Crome 203 bin, stock LS motor, 4500rpm launch limit, ignition values borrowed and modified from previous stock-ls-jason.bin (this ones alot better)

FooK

wierd half 110 final 17 psi.bi 2.0/VTEC, 1100cc injectors, T4/T67, Motorola 2.5 bar on half 93 pump half 110 racegas blend. Tuned to 17-18 psi, run R5671-A10 or R5672-A10 plugs.

Joseph Davis

~15Sept05-CromeTuned.bin LS/VTEC, 450cc, t3/t4, 10 psi, fuel at 11.5 in boost, elev: 4500ft.

eficker